Filter
Top Products
English
10
NOTE: For optimum run-time, do not use rechargeable
batteries. Use only high-quality alkaline batteries. The
DS500 may be fully charged before inserting the unit into
the DS505 for additional run time.
5. Attach the DS505 to your asset by inserting four #8 screws
(not provided.) in the mounting holes (A) as shown.
6. Close door.
DS510 INDOOR MOTION DETECTOR
IMPORTANT: Before inserting battery,
make contact with the gold (+) and the
(+) battery terminal at the same time
with a metal object to reset indoor
motion detector circuitry.
1. Insert the enclosed CR-123 lithium ion battery into the battery
compartment on the back of the DS510. Always insert batteries
correctly with regard to polarity (+ and -) marked on the battery
and the equipment.
2. The DS510 indoor motion detector can be mounted flat against
a wall or in a corner using two # 8 screws.
3. Open the DS500 charging port door to
access the charging port.
4. Insert the DS500 MOBILELOCK
TM
unit as
shown. Be sure it has complete contact with
the DS510 connector.
Recommended locations
• Recommended for use in enclosed areas,
offices, climate controlled storage, and moni-
toring interior spaces.
• The DS510 functions best when areas being
protected are bounded by solid barriers. Walls and floors
provide good backdrops for detecting changes in infrared
energy.
3V
CR123
• The motion detector covers an area 50 feet (15.24 m) out and
over and angle of 105˚. For best detection, locate the motion
sensor so that intruders move across
detection zone patterns, rather than
toward or away from the sensor.
• Check areas for potential sources of
false alarms. Remember that the sen-
sor responds to quick changes in heat
patterns within its coverage pattern.
Avoid placing in direct or reflected
sunlight, or near objects that can be
heated quickly by sunlight. Do not
place the product looking at windows.
Don't place it near heating or cooling
sources, like heater ducts or air condi-
tioners, which might direct hot or cold
air onto the sensor. Avoid appliances
such as space heaters which can rapidly heat up.
• Check that premises are cleared and assets secured before
arming.
• Check that motion detectors are not obstructed. Do not allow
sources of heat in range of the motion sensors.
• Take into consideration the normal use of the area:
Are there bats, mice, or other animals that could activate the
sensor?
• Do not obstruct the coverage pattern with furniture or other
equipment.
Test the System
It is recommended to test the system periodically. This system test
will test each of the active sensors.
NOTE: The MOBILELOCK
TM
website and phone menu is subject
to change.
DS500 E,Sp 8/9/06 11:04 AM Page 10