Filter
Top Products
English
8
Charging the DS500
IMPORTANT: The unit MUST be connected to a power source to
begin the activation process. The internal battery is not fully
charged when shipped. The battery will take up to 8 hours to
charge completely. Some batteries perform best after several full
charge/discharge cycles.
CAUTION: POTENTIAL EQUIPMENT MALFUNCTION OR
FAILURE. Use only D
E
WALT power supplies marked for use with
this product. Other power supplies may damage the product.
1. Plug other end of the adapter into the appropriate electrical
outlet.
2. Open door to charging port (Fig. 1).
3. Insert adapter with arrow facing up (Fig. 2).
The MOBILELOCK
TM
unit will beep to confirm that the unit is con-
nected to power. You can safely leave the adapter connected to the
MOBILELOCK
TM
after charging is complete. This will not damage
the battery.
NOTE: There is no battery level indicator on the MOBILELOCK
TM
unit. This information is available through the MOBILELOCK
TM
website and phone menu system. After you have activated the
notification service, you will be able to see the battery level on the
MOBILELOCK
TM
website (www.dewalt.com/mobilelock) or hear it
through the phone menu system. In addition, low battery and full
FIG. 1
FIG. 3
FIG. 2
INITIAL SETUP
battery notification will be sent to the phone number and/or e-mail
address(es) provided.
Activate
IMPORTANT: The alarm is non-functional until
the notification service is activated. Be sure the
following necessary information is available
prior to activating:
1. Electronic serial number (ESN) on the
back of the MOBILELOCK
TM
unit.
2. Credit card information.
3. Notification phone numbers and/or e-mail address(es).
The DS500 must be connected to power when the notification
service is activated.
Go online to www.dewalt.com/mobilelock or call customer service
at 1-877-456-LOCK (1-877-456-5625) to activate the
MOBILELOCK
TM
service. During this process you will need to do
the following:
1. Register using the Electronic Serial Number (ESN) on the back
of the MOBILELOCK
TM
unit.
2. Create an account profile.
3. Select a monitoring plan.
Customize Alarm Settings
All customizing can be done online or through the phone menu
system. Go online to www.dewalt.com/mobilelock or call 1-410-329-
9477 to customize the alarm settings. During this process you will
need to do the following:
1. Choose contact phone numbers and/or e-mail address(es).
The MOBILELOCK
TM
notification service will call up to three
people in the event of an alarm. Low battery and full battery
notices can be sent via phone or e-mail.
2. Choose the sensors needed for the asset you want to protect.
DS500 E,Sp 8/9/06 11:04 AM Page 8