Filter
Top Products
English
9
Mounting
DS500 MOBILELOCK
TM
UNIT
HINT: To improve location accuracy, follow these recommendations:
• Best locations are outdoors with line of sight to the sky.
• Keep away from underground locations.
• Avoid structures with metal or concrete roofs, tall buildings, and
dense foliage.
• Windows with sun shielding films can block satellite signals.
• Radios and other electronic equipment may interfere with or
block satellite signals.
Use the magnets on the back of the MOBILELOCK
TM
unit, two #8
screws (not included) or two bolts (not included) as appropriate for
the material to which it is affixed. If removed from the mounting
surface and the tamper switch on the back of the unit has been
selected as ON, a tamper message will be sent. This alarm will be
sent when the unit is both armed and disarmed. To eliminate false
alarms, be sure that the MOBILELOCK
TM
unit is secure or hidden
so it is not removed.
NOTE: If using the door contact sensor, place the magnet on the
door jam no more than 3/8" (9.5 mm) from the magnet icon on the
left side of the MOBILELOCK
TM
unit (mounted on the door).
3/8" (9.5 mm)
To permanently mount the door contact magnet:
1. Remove tape from back of magnet.
2. Remove the cover to expose the two mounting holes.
3. Insert screws (not included) into mounting holes.
DS505 EXTENDED RUN-TIME ADAPTER
1. Open the DS505 door.
2. Open the DS500 charging port door to access the charging port
as shown.
3. Insert four D-size alkaline batteries (supplied).
4. Insert the DS500 MOBILELOCK
TM
unitas shown. Be sure it has
complete contact with the DS505 connector. The
MOBILELOCK
TM
unit will beep when the batteries and the unit
are properly inserted to indicate power is provided to the
MOBILELOCK
TM
unit.
D-SIZE
ALKALINE
BATTERIES
A
A
A
A
DS500 E,Sp 8/9/06 11:04 AM Page 9