Filter
Top Products
©2003 Edelbrock Corporation
Brochure No. 63-0148
Rev. 2/03
Page 14 of 23
3.1 Nitrous Electrical Components Bill of Materials (BOM)
Nomenclature Descriptions:
ATO… the fuse configuration is ATO. When replacing this fuse, ask for an ATO fuse.
“a”… Amperage.
Important: The wiring hardware and instructions included with this kit are intended for 12-volt electrical systems only.
Before attempting to wire your Edelbrock Performer nitrous oxide system, examine and follow the wiring diagram on
the following page. Please call the Edelbrock Technical department with any questions concerning electrical wiring.
When working with electrical systems in your vehicle, it is a good idea to have a service manual that features your vehicle.
It is also good practice to have a book that specializes on the specialized techniques required when working with
vehicular electrical systems.
3.0 Electrical System Installation
It
em # Quantity Description
1 1 ea. Activation microswitch
2 1 ea. Activation microswitch bracket (not shown)
3 2 ea. Activation microswitch mounting nut
4 2 ea. Activation microswitch mounting screw
5 1 ea. 30 amp relay
6 1 ea. Wire harness with integral relay/fuse holder
7 1 ea. Red lighted toggle switch
8 2 ea. 18/22g female spade connector, Nylon insulated
9 2 ea. 14/16g female spade connector, Nylon insulated
10 1 ea. 14-16g male spade connector, Nylon insulated
11 1 ea. 16/18, splice connector
12 1 ea. 14/16g 3/8” ring terminal, Nylon insulated
13 3 ea. 18/22g ring terminal #10 Stud, Nylon insulated
14 2 ea. 18/22g ring terminal #8 Stud, Nylon insulated (.187)
15 2 ea. 18/22g female spade connector, Nylon insulated
16 1 ea. 15 amp ATO blade fuse