Filter
Top Products
5
© 2009 Directed Electronics
Disarming
To disarm the system, unlock the doors using your factory keyless
transmitter. The siren sounds twice, and the parking lights flash
twice. If the siren sounds either four or five times when disarming,
refer to the Diagnostics section of this guide. This is called Tamper
Alert.
Disarming without a transmitter
This feature allows you to override the system without the transmitter
should it be lost, damaged or disabled. To do this, you must have the
vehicle’s ignition key and know where the Valet switch is located.
T urn the ignition to the run position.
Press and Release the Valet switch,
within 10 seconds.
After a few seconds the LED will stop flashing and the vehicle should
start. If it does not, you may have waited too long. Turn the ignition off
and try again.
NNoottee::
Your installer can program the number of times to
PPrreessss
and
RReelleeaassee
the Valet Switch.
See Programming Options
section of this guide.
DRW-35