Filter
Top Products
6
© 2009 Directed Electronics
Valet mode
You can prevent your system from arming, by using Valet Mode. This
is very useful when washing the vehicle or having it serviced. In Valet
Mode the system will not arm, but all convenience functions (door
locks, trunk release, etc.) will work normally.
To enter or exit Valet
®
Mode with the Valet switch:
T urn ignition to on position,
then turn to of f position.
Press and release the Valet
switch within 10 seconds.
The status LED will light steady if you have entered Valet Mode. To
exit Valet Mode, repeat the steps above. The LED turns off when exit-
ing Valet Mode.
Remote valet
Remote Valet is a convenient feature that makes bypassing the secu-
rity system easier. This feature makes it possible to exit or enter Valet
Mode using your factory keyless transmitter.
1. Open any door.
2. Press LOCK on the transmitter.
3. Press UNLOCK on the transmitter.
4. Press LOCK on the transmitter.
The status LED will st ay on if you have entered Valet Mode, and it will
go out if you exited Valet Mode.
DRW-35
The remote Valet feature will not work with all factory
Keyless system. Some keyless entry systems do not
work with a door open.