Filter
Top Products
10
© 2009 Directed Electronics
Table of zones
The number of LED flashes the system uses to identify inputs is rep-
resented by a Zone. The standard Input assignments for zones are
described below.
Zone/LED Flashes Input description
1
Instant trigger - often used
for hood/trunk pin switches
2 Instant trigger - a heavier impact
detected by the shock sensor
3 Door switch trigger
4 Optional sensor
5 Ignition trigger
The LED will not report if the Warn A way response is triggered.
Rapid resume logic
This system will store it s current state to non-volatile memory. If
power is lost and then reconnected the system will recall the stored
state from memory. This means if the unit is in Valet Mode and the
battery is disconnected for any reason, such as servicing the car,
when the battery is reconnected the unit will still be in Valet Mode.
This applies to all st ates of the system including arm, disarm, and
Valet Mode.