Filter
Top Products
15. Reinstall ceramic box on driver’s side.
14. Slide long nut strip into end of bumper and use 3/8” x
1” bolt and 3/8” lock washer and tighten bolt.
13. Drill 3/8” hole through bottom of bumper, using base-
plate as template. This is located under bumper on
passenger’s side.
12. Next, drill 3/8” hole, using baseplate as template,
through flange on vehicle. Install 3/8” x 1” bolt, 3/8”
lock washer, and 3/8” hex nut through drilled hole.
Tighten all bolts before proceeding. NOTE: Use bolt
torque chart on front.
14. Install 3/8” x 3-1/2” bolt, 3/8” lock washer, and install
through base plate frame, and thread into threaded nut
plate on inside of frame. Do not tighten yet.
13. On passenger’s side, drill top hole of baseplate using
3/8” drill bit, using baseplate hole as template. This
hole must line up with hole on inside of box frame.
15. Next, drill 3/8” hole, using baseplate as template,
through flange on vehicle. Install 3/8” x 1” bolt, 3/8”
lock washer, and 3/8” hex nut through drilled hole.
Tighten all bolts before proceeding. NOTE: Use bolt
torque chart on front.
TOYOTA ECHO
SCION XA