Daewoo D25S-3(B3.3) Automobile Parts User Manual


 
Diesel Engine Engine Testing
93
If the stamp lines are out of alignment, loosen nut (7).
Align the stamp lines by rotating the coupling.
Tighten the nut.
Torque Value: 31 N•m [23 ft-lb]
Checking and Adjusting with the Measuring
Device Method
NOTE: Set the No. 1 cylinder at compression top
dead center (TDC) by aligning the pointer
on the gear cover with the TDC line on the
crankshaft pulley.
Remove the distributor head bolt and copper washer
from the injection pump.
Discard the copper washer.
Install the dial gauge, Part No. 3377259, into the
distributor head.
NOTE: Check that the stylus end of the dial gauge
contacts the plunger head.
14900072
14900073
14900074
14900075