Daewoo D25S-3(B3.3) Automobile Parts User Manual


 
Diesel Engine Complete Engine
57
Rotate the camshaft to set the piston at bottom dead
center.
Remove the mounting capscrews of the connecting
rod cap.
Check the number stamped on the connecting rod
cap and the cylinder. The numbers must match.
NOTE: If there is no number stamped on the
connecting rod cap, stamp the correct
number on the camshaft end of the cap.
Tap the cap with a plastic hammer, and remove the
connecting rod cap and bearing.
Push a wooden bar or hammer handle through the
cylinder from the lubricating oil pan side of the block.
Support the piston at the cylinder head side of the
block, and push the bar in far enough to remove the
piston and connecting rod assembly.
Piston and Connecting Rod Assembly -
Disassembly
Remove the snap ring on one side of the piston using
pliers.
Remove the piston pin, and separate the piston and
connecting rod.
NOTE: If the pin does not come out, place the
assembly in hot water prior to disassembly.
00900193
00900195
00900196
00900197