Filter
Top Products
OPTION PROGRAMMING
OPTION DESCRIPTIONS:
1. NOT USED: No Option
2. Door Lock Pulse Time:
Controls the amount of time for lock/unlock pulse. The standard setting is 0.75 for most vehicles. A 3 sec. setting is
required for 1980’s/90’s European Vacuum or Pneumatic door lock systems.
3. Double Unlock Pulse:
The unit will send 2 unlock pulses when the #2 Unlock button is pressed. This feature may be required for interfacing
this alarm with an existing Factory Keyless Entry or Alarm system in a vehicle. These systems are found on some
Nissan, VW, Toyota, and Lexus vehicles.
4. Engine Monitoring:
This option sets how the unit monitors your engine. You can program either for Tach mode in which the unit uses a
Tach signal (RPM) or for Tachless mode that monitors voltage level. See pages 9-10 for more information and
additional steps for actual Tach learning and Tach finder modes.
5. Remote Start Run Time:
This option controls the engine run time for remote start. You can select either 24 or 36 minutes.
6. Smart Tachless Voltage Adjustment:
This option controls the voltage reference point when using Smart Tachless mode. Either tapping the brake or pressing
the Start button on the remote raises or lowers the reference level in 1% increments from 80%-%100. The default
voltage setting is 90%, which works well for most vehicles. See page 9 for additional Smart Tachless mode information.
7. Option Reset:
This option allows you to restore all programmable options to factory default values. Go to the 7
th
option and press
the Start Button on the remote. The unit will flash the lights 2 times and all values will be reset to Default.
13