Filter
Top Products
POWER DOOR LOCK WIRING
AFTERMARKET MOTOR/DOOR LOCK WIRING
REVERSE POLARITY DOOR LOCK WIRING
GREEN
GREEN
FUSED
FUSED
RED
RED
+12V
+12V
BLUE
BLUE
+
+
86858685
8685
8685
8787
8787
3087A3087A
3087A3087A
+
L
CUT
UL
CUT
MASTER
SWITCH
IMPROVED “SMART” TACHLESS MODE
This RS800 Series II system includes a unique voltage monitor system called “Smart Tachless” mode. This mode allows
this unit to efficiently start an engine without the use of a tach signal wire. These modules actively monitor the voltage
reference on the vehicle every time remote start is requested.
IMPORTANT NOTES: (1) NO SETUP is required for the RS800 improved “Smart Tachless” Mode (PLUG and PLAY). (2)
On the rare occasion that “Smart Tachless” mode does not operate satisfactorily, change the voltage reference level by
removing jumpers as described below, or use a verified tach source with the red/white tach wire.
SMART TACHLESS JUMPERS: (Remove Access Door on top of module)
The purpose of the jumpers is to reduce the starter cranking time [if needed] when in “Smart Tachless” mode only.
JUMER PIN ORIENTATION: Looking at remote start upright with harnesses facing down (or towards you).
To shorten the crank time one level, remove the jumper at the far right. Test the unit and see if the decrease is correct. If
a shorter crank time is still required, then remove the middle jumper. Test the unit and see if the decrease is correct.
There are only (2) adjustments. Removing the third jumper will not make any change to the crank time.