Filter
Top Products
TACH FINDER MODE & TACH PROGRAMMING
TACH FINDER (OPTIONAL):
1. Open hood (or ground Gray hood pin wire if no hood pin is installed)
2. Start Engine with the key.
3. Press the Program button for 2 seconds
4. Lights will flash if the Tach wire is connected to a valid tach source. If lights do not flash, then try a different wire.
5. Once Tach is located then turn off engine and close hood to abort (un-ground Gray wire).
6. See Tach programming below.
TACH PROGRAMMING:
1. Open hood (or ground Gray hood pin wire if no hood pin is installed.)
2. Red/White wire should be connected to a valid Tach source.
3. Start engine with key.
4. Press program button 5 times, then wait for 5 light flashes.
5. Push program button again 4 times. (You must get a light flash after each button press. If the unit did not flash
the lights, then it did not register your press.)
6. Tap the Brake Pedal. The unit will read the Tach source and flash the lights once for program confirmation.
7. If lights do not flash once for confirmation, then try another tach source or try the tach finder.
TRANSMITTER PROGRAMMING
Note: All transmitter codes must be learned at time of programming!! The RS800 allows storage of up to 4
different transmitter codes.
1. Open Hood. (Ground the Gray wire if no hood pin is installed.)
2. Turn key to the ON position.
3. Press Programming button 4 times. After a few seconds, the unit will flash the parking lights 4 times.
4. Press the Start Button of the transmitter to be coded. You should get 2 light flashes indication the unit is waiting for a
2
nd
code, then press the Start Button of a second transmitter, the unit will flash 3 times indicating its waiting for the 3
rd
code and lights will flash 4 times for 4
th
code. If all 4 codes are learned, the unit will automatically exit code-learning
mode, otherwise turn key OFF and close hood.
8