Filter
Top Products
9
PROGRAMMABLE OPTIONS
1. Turn the Ignition ON and press the Override/Program button 7 times within 10 seconds.
2. Turn OFF Ignition. LED will flash slowly once per second as and indicator the system is in programming mode.
3. Within 20 seconds, press the Override/Program button the number of times that corresponds to the feature list
below. The siren will chirp for each button press. DO NOT LOSE COUNT!! You can hold down the button for
3 seconds and release to get 2 chirps. A 3-second button press is the same as pressing the button 10 times.
4. When you get to the desired option number, turn the Ignition from OFF to ON to toggle between the default
and alternate settings. The siren will chirp once or twice confirming that the Default or Alternate Option was
selected. See Below for Option numbers, descriptions, and values. Ignition should be left in the OFF position
once your have made the selection.
5. At this time, if you need to change more options, repeat steps 3 & 4 above.
6. To exit programming Mode, Turn Ignition ON and press the Override/Program button once.
OPTION PROGRAMMING CHART
Option #
Description Default
(1 chirp)
ALTERNATE
(2 chirps)
1 Flashing Lights
ON
OFF
2 Door Warning Delay
10 Sec.
60 Sec.
3 Horn Chirp Time
Normal (40ms)
Short (20ms)
6 Siren/Horn Confirmation
ON
OFF
8 Passive Arming
OFF
ON
10 Door Trigger Input Polarity NEGATIVE POSITIVE
14 Allow Panic Mode OFF ON
15 Horn or Siren output
(White/Red wire)
HORN
SIREN
16 Mode A/B Select Mode A Mode B
25 Restore Default YES N/A
1. FLASHING LIGHTS
This option on controls whether the CS-883OEM system flashes the vehicles parking lights. If your vehicle
already flashes the parking lights when using the keyless entry remotes, then you may choose to disable this
option