Filter
Top Products
2
TABLE OF CONTENTS
Installation Cautions & Component Mounting…….……………….…………………………………………………..2
Wiring………………………………………………………………………………………………..…………….…………3-5
Installation Modes “A” & “B”……………………………………………………………………………………………6-7
System Wiring Diagram………………………………………………………………………………….………………….8
Programmable Options………………………………………………………………………………………………….9-10
Operation……………………………………………………………………………………………..…………………..11-12
INSTALLATION PRECAUTIONS & WARNINGS
BEFORE BEGINNING, check all vehicle manufacturer cautions and warnings regarding electrical service (AIR
BAGS, ABS BRAKES, BATTERY, ETC.).
DO NOT ROUTE ANY WIRING THAT MAY BECOME ENTANGLED with brake, and gas pedals, steering
column, or any other moving parts in the vehicle.
USE A VOLT/OHM METER if you need to test any wire. Test Lights can damage a vehicle’s computer systems.
COMPONENT MOUNTING
Control Module: DO NOT mount wiring harness or control module where they can become entangled with
moving parts such as brake/gas/clutch pedals, or the steering column! The control module should be mounted in
a concealed location. Do not mount the control unit in the engine compartment.
LED: Mount in a visible location on the dashboard or console. The LED is your visual deterrent to a would-be
intruder or thief, plus it is required when programming certain options of the system.
Valet/Program Button: Mount button in a hidden but accessible location. It is REQUIRED for emergency
disarm, programming, and valet mode.