Filter
Top Products
12
OPERATING INSRUCTIONS
VALET MODE
To disable alarm functions of the 883 system, turn the Ignition ON and press the override/program button 3 times
within 8 seconds. Turn off ignition, after 8 seconds, the dash LED turns on solid as an indicator that the system is
in valet mode. Repeat these steps to exit VALET mode. The LED will go out, system will chirp (2) times and the
light will flash (2) times when exiting valet mode.
When in VALET mode the siren will still chirp for lock/unlock confirmation even though alarm functions are
disabled. The CS-883 system will chirp 2 times when locking the doors and 3 times when unlocking the doors.
PANIC MODE (Programmable Option)
To activate your system during an emergency situation or to attract attention to your vehicle, press the Lock
button on your remote 3 times within 5 seconds. This will activate a 30-second alarm trigger. Press any button
on your remote to disarm.
FACTORY TRUNK RELEASE SENSING
If the CS-883 system is installed in a vehicle with trunk pop or hatch release button on the Factory Remote, there
is a special input wire that will prevent the system from triggering if the trunk button on your remote is pressed
while the system is armed.
OPEN DOOR WARNING
If the vehicle door is left open when arming system, you will hear 5-siren chirps after 10 seconds. This may be
programmed for a 1-minute delay for vehicles with delayed dome lights using program option #2.