Filter
Top Products
Advanced System Functions
The optional Secure Valet Switch prevents the alarm from being put into valet mode through cycling the ignition on/off five times. The Secure Valet
Switch is more secure than traditional toggle / valet switches because it requires a two digit code.
IMPORTANT: The first two digits of the RPS unlock/disarm pass code will be the default pass code for the secure valet – you do not need to
program them independently. If you are not using the RPS unlock, following the below procedures to program your secure valet pass code;
STEP 1:Turn on Option 3-10-III. (Dealer programmed option)
STEP 2: Turn ignition key to the “on” position.
STEP 3: Hold down the valet switch for 1.5 seconds. The LED on the valet switch will begin to flash rapidly with successful completion of this step.
STEP 4: Enter the first digit of the desired two digit pass code by depressing the switch the number of times that coordinates with the desired first
number. For example, to enter 3, depress the switch 3 times, then wait.
STEP 5: The LED will confirm the first number by flashing BLUE slowly. Once the LED begins to flash rapidly, enter your second number by repeating step 4.
STEP 6: Turn the ignition off - the Secure Valet Switch is now programmed. Follow steps 3 – 5 to enter your Secure Valet code.
Secure Valet Switch
Timer start mode is used to cool or warm the vehicle automatically without use of the key or the remote. While engaged, timer start will
activate even while the remote is out of range. Tap the Function button twice followed by the Unlock button to activate timer start
mode. The remote will beep once and the timer start icon will illuminate just above the clock icon. Repeat the same step to turn off timer
start mode. Timer start mode will be cancelled any time the vehicle is started manually or remotely. To change from the default setting to
optional settings, see your place of purchase.
To program a specified start time, used for Option 3, perform the following steps;
STEP 1: Enter remote programming mode by holding the Trunk and Key/Start buttons simultaneously for 2.5 seconds. The remote will
beep once and the LCD will read “REMOTE MENU” to indicate that you have successfully entered programming mode.
STEP 2 : Scroll through the remote options by taping Function button . Once the TMR icon, Engine icon and Clock flashes tap the Lock button
to set the hour, the Unlock button to set the minute.
STEP 3: Exit remote programming by holding down the Trunk and Key/Start buttons simultaneously for 2.5 seconds. The remote will
beep indicating that you have successfully exited programming. The vibration icon will remain illuminated on the LCD indicating the remote is in
remote mute/vibration mode. Remember, after you set the time, you must activate timer mode before the vehicle will start. Tap the Function button
twice followed by the Unlock button to activate timer start mode. The remote will beep once, LCD flash “TIMER START ON” and the timer
icon will illuminate just above the clock icon.
Timer Start Mode
Advanced System Functions
!
!
!
!
!
!
!
!
!
!
!
By Firstech, LLC 34 35 By Firstech, LLC
2W901R-SS_ES USER GUIDE.indd 35-36 2011-3-26 14:34:21