Filter
Top Products
7
Using Your Remote Starter
(cont’d)
Using the “Quick-stop” Feature
If you want to make a short stop and leave your vehicle running (to keep
the interior warm or cool, for instance), the quick stop feature allows you
to do this while keeping your vehicle secure and your keys with you.
To engage quick stop:
1.Stop the vehicle and place the transmission in PARK.
2. With your foot off the brake pedal, press ARM, then press START
within 2 seconds on the remote control. The parking lights will turn
on, indicating that the vehicle is now running via remote start.
3.Remove the keys from the ignition and exit the vehicle.
Press LOCK to lock the vehicle doors if desired.
Note: Do not leave children or animals unattended in the vehicle
when using the quick stop feature.
Automatic Convenience Options
The PowerCode PC 7400
TM
performs a variety of automatic functions to
enhance security and comfort. Some of these features are programmable
at the time of installation. Please see your installer for further details.
Illuminated Entry
When the system is UNLOCKED, the vehicle courtesy lights will turn on
for 1 minute, or until the vehicle is started or the system is re-locked.
Illuminated Exit
When turning ignitioin off, the vehicle courtesy lights will turn on for 1
minute, or until the PowerCode PC 7400
TM
is armed.
Ignition Lock
If all doors are closed and the vehicle is started with the key, the doors
will automatically lock.
Ignition Unlock
When removing the key from the ignition, the doors will automatically unlock.
System Maintenance
Changing the Remote Control Battery
The two 3-v lithium batteries (CR2016) supplied in your remote
control should last approximately one year, depending on usage.
When the battery begins to weaken, you will notice a decrease in
range, or the distance from your vehicle that your remote transmitter
will operate. Follow the instructions below to change the remote
transmitter battery.
1.Insert the edge of a coin into the slot at the side of the remote
control. Twist the coin to pry the remote control halves apart.
2.Remove the old batteries and replace with new ones. Be sure
to observe the (+) and (-) signs in the battery compartment.
3.Carefully snap the case halves back together, then test the
remote control.