Filter
Top Products
6
Using Your Remote Starter
Starting Your Vehicle
The remote start function is activated by pressing LOCK and then
pressing START within 2 seconds on the remote control. The system
will check the vehicle to ensure that it is safe to start, and if all safety
parameters are correct, the engine will start within 5 seconds (diesel
engines will take longer.) Press and hold START again to turn off
the vehicle.
If your vehicle stalls or does not start...
If the vehicle stalls or does not start, the PowerCode PC 7400
TM
will
pause 5 seconds, then try 3 more times to start the vehicle (a total of
four attempts). The system pauses 5 seconds between each start
attempt. If the vehicle does not start after the fourth attempt, the
PowerCode PC 7400
TM
will abort the start process.
Your vehicle can be started by remote control whether the vehicle is
locked or unlocked.
Remote Start Safety Features
For safety and security reasons, the PowerCode PC 7400
TM
will shut
off the vehicle during remote start if any of the following occur:
• The vehicle hood is opened
• The brake is pressed before the vehicle ignition is turned on
with the key
• The engine reaches 3 times its normal idle*
As a safety precaution, the vehicle will shut off if left unattended for 12
or 25 minutes, depending on the time preset by your installer.
Entering the Vehicle While It is Running via Remote Start
1.Press UNLOCK to unlock the door(s) and turn off the starter
disable (if it is not already off).
2.Enter the vehicle. Do not press the brake pedal.
3.Insert the key into the ignition and turn to the ON position.
4.Press the brake pedal. The remote starter disengages and the
vehicle will operate normally.
Pre-Heating or Pre-Cooling the Interior of the Vehicle
Before exiting the vehicle, set the temperature controls to the desired
setting and operation. After the PowerCode PC 7400
TM
starts the
vehicle, the heater or air-conditioning will activate and heat or cool
the interior to your setting.
Turning on the Rear-Window Defroster (if connected)
While the vehicle is running via remote start, press DEFRST on the
remote control. The vehicle defroster will activate and run for 10
minutes, or for your vehicle’s preset time limit.