Filter
Top Products
5
Using Your Remote Transmitter
(cont.)
Two-Stage Door Unlock
If this feature is enabled on your system, pressing UNLOCK one time
will unlock only the driver’s door. Press UNLOCK again within 1
minute to unlock all doors.
Activating the Trunk Release Feature
Press and hold TRUNK to open the vehicle trunk or hatch (if equipped
and connected). If this button is used to operate another accessory,
the accessory will stay active for as long as the button is held.
Turning on the Vehicle Headlights
Press and hold the LOCK button to turn on the vehicle headlights.
The lights will stay on for 20 seconds, or until LIGHTS is pressed again.
Using the Progressive Car Finder Feature
Press FIND on the remote control to locate your vehicle. The horn will
emit five short “honks” at low volume, increasing in volume each of
three times the button is pressed.
Personal Protection Alarm (Panic)
Press and hold the PANIC button to activate the vehicle horn and
parking lights for 30 seconds. (If the vehicle horn is connected, the
horn will “honk” for 30 seconds.) Press any remote control button to
turn off the Panic alarm.
Remote Start / Stop Feature
Press LOCK, then press START within 2 seconds on the remote control.
If all safety parameters are correct, the engine will start within 5 seconds
(diesel engines will take longer.) Press and hold START again to turn
off the vehicle. (Turn to page 6 for more on remote start features.)
Using Second Car Mode
If this feature is enabled, one transmitter will control two vehicles
equipped with a Power Code
M
system. To operate the second vehicle,
press the shift button, then within two seconds, press the desired
function button.