Filter
Top Products
Nothing Comes Close to a Cobra
®
21
20
English
Getting Started
Y
ourDetector
Muting Alerts
•
Manual Mute
Press MUTE/button momentarily to turn Off Audio Alert during an Alert
condition. Press MUTE/
button again during alert to turn On Audio Alert.
After current alert is gone, detector will un-mute and next alert sounds.
Auto Dark
•
When Auto Dark screen is engaged, a small dot displays
at bottom of screen to show that power is on. Touch any
button to recall Standby screen. Any alert will also exit
Auto Dark mode.
IntelliShield Highway/City Modes
•
Your detector is equipped with IntelliShield false signal
rejection technology which consists of a Highway mode
and three different levels of City modes: City X, City X Beep
Off and City X+K.
Highway mode provides full response to all signals detected.
The City modes reduce false alerts while you are driving in
or near urban areas where there are many sources for
conflicting X or K band signals such as microwave towers
and automatic door openers. The factory setting is
Highway. The factory City mode default setting is City X;
it can be changed in Menu mode (see page 12).
You can toggle between Highway and City modes by
pressing the City
button.
NOTE: When you change to City mode, the unit will
enter whichever city default mode is set at the time.
Programming Overview
•
Begin all programming or setup with MENU/SAVE button.
Select this to change USER or ALERT settings. USER
settings customize how system handles alert filtering,
audio-related options, visual options and system-related
options. ALERT settings determine which ALERT types
are activated. USER and ALERT settings on the XRS
R10G model include GPS-related features.
Press MENU/SAVE button again to save feature and
function changes and return to Standby screen. If a
button is not pressed within 15 seconds while in
Setup/Programming mode, Standby screen displays and
settings made up to this point are saved automatically.
Enter USER or ALERT settings sub-menu and display
shows left arrow
, down arrow and right arrow.
Arrows correspond with arrows on DIM, MUTE and CITY
buttons on RDU.
Press left arrow
to return to previous screen. Press
right arrow
to access next screen. Press down arrow
to make changes. Press MENU/SAVE button to exit
setup program and save new settings.
Each of these functions and settings are explained in
SETTINGS section of this manual.
NOTE: Advancing at the end of menu returns to
beginning of menu.
Setup/Programming mode cannot be accessed
during an alert. Unit does not detect signals while
in Setup/Programming mode.
You can restore all settings at once to factory
state in the USER settings sub-menu.
Programming
USER ALERT
Choos e Menu Typ e
YourDetector