Filter
Top Products
User-selectable features
Your Sabre II vehicle security system allows you to set many of its features to your
own personal preferences. We have made the programming procedures very simple:
to make a change, you just press the PlainView switch a few times. The system
comes from the factory with all of its features pre-programmed as noted in the table
below and on the next page. To change any of the settings, use the following
procedure. To restore the feature to its factory setting, just repeat the procedure:
1. Select the feature you wish to program from the table below and on the following
page. Note the number of momentary (spring-loaded) presses.
2. Turn your vehicle’s ignition switch to its “ON” position.
3. Enter your valet code (see page 8) on the PlainView switch.
4. When the LED turns on, immediately press and release the momentary side of
the switch the number of times indicated in the third column of the programming
table for the feature you selected (to help you count, you will hear a single chirp
confirmation each time you press the momentary side).
a. If noted, perform the “Secondary action.”
5. Wait 3 seconds. You will hear 1-3 chirps (as noted in the “Program completion
confirmation” column) and the LED will turn off. Turn the ignition off.
6. Repeat steps 1-5 for any other features you wish to program.
Programming table for user-selectable features
Feature
Factory
setting
# of
momentary
presses
Secondary
action
Program
completion
confirmation
Result
AutoArming
ON
4
—
1 chirp = OFF
2 chirps = ON
Change state from
ON to OFF or vice-versa
AutoArm
& Lock
OFF
5
—
1 chirp = OFF
2 chirps = ON
Change state from
OFF to ON or vice-versa
FACT
ON
6
—
1 chirp = OFF
2 chirps = ON
Change state from
ON to OFF or vice-versa
Chirp
confirmation
ON
9
—
1 chirp = OFF
2 chirps = ON
Change state from
ON to OFF or vice-versa
Add a new
remote to
channel 1
(arm/disarm)
—
11
Press remote control button 1 1 chirp
Button 1/channel 1 code
of the new remote control
has been memorized
Add a new
remote to
channel 2
(optional
remote
accessory)
—
12
Press remote control button 2 2 chirps
Button 2/channel 2 code
of the new remote control
has been memorized
continued . . .
13