31
© 2006 directed electronics
Fifteen seconds
after the siren chirps begin, the siren’s output will
change to a continuous blast.
From this point on, when the ignition key is turned off, the VRS
®
will immediately turn on the starter kill. This will prevent the
vehicle from being restarted, thus immobilizing it at that spot.
Three minutes
after the constant siren output begins, the flashing
parking lights and the siren will stop. The starter kill will remain
active until the system is disarmed. If the door is opened or the
ignition is turned off and on in an attempt to restart the car, the
siren and light flashing will begin again.
disarming the vrs
®
Take the time to familiarize yourself with the VRS
®
triggering se-
quence and the disarm procedure. It is important to recognize
and identify the VRS
®
trigger sequence and know how to disarm
it in case of accidental activation.
Once the VRS
®
is armed, it does not disarm automatically. You
must disarm it the next time you operate the vehicle. You must
disarm it with one of the following procedures:
If the system has not entered the triggered sequence (siren has
not started chirping):
1. Turn the ignition on.
2. Press on the remote control for one second.
The lights will flash and the siren will chirp
➜