Filter
Top Products
22
© 2006 directed electronics
Example
If Zone 3 was active or triggered, the LED will blink three times
with a two-second pause. Then it will blink three times again,
and repeat until the ignition is turned on.
ccooddee hhooppppiinngg
The receiver and remote controls each use mathematical
formulas called algorithms to change their codes each time the
remote control is used. This technology has been developed to
increase the security of the unit. The control unit knows what the
next codes should be. This helps to keep the remote control "in
sync" with the control unit even if you use the remote control out
of range of the vehicle. However, if the remote control has been
pressed many times out of range of the vehicle, or if the battery
has been removed, it may get out of sync with the control unit
and fail to operate the system. To re-sync the remote control
simply press of the remote control several times within range
of the vehicle. The alarm will automatically re-sync and respond
to the Remote Controls normally.
note: Your system stores the last six triggered zones in
memory. If your system has been triggered but the LED
has been reset by turning on the ignition, your dealer can
still recall the last six zones that were triggered. Contact
your dealer for details.