Filter
Top Products
8
© 2006 directed electronics
uussiinngg yyoouurr ssyysstteemm
The buttons described in this manual correspond to the standard
configuration. Remember, this is not the only way your Remote
Control may be set up. It can be custom configured to meet your
needs.
active arming
You can activate, or arm, the system by pressing on your
remote control for one second. When the system arms, you will
hear a short siren sound, or chirp, and the parking lights will
flash once. If the vehicle’s power door locks have been connected
to the system, the doors will lock.
While the system is armed, the status LED will flash approxi-
mately once per second, indicating that the system is actively
protecting your vehicle. If you hear a second chirp after arming,
and see the status LED flashing in groups, refer to the Diagnostics
section of this guide. This extra chirp is called Bypass Notification.
passive arming
The system also can be programmed to arm itself automatically
(called passive arming). If the system is programmed for passive
arming, it will automatically arm 30 seconds after the ignition is
turned off and the system "sees" you leave the vehicle by opening
and closing a door. Whenever the system is in its 30-second
passive-arming countdown, the status LED will flash twice as
➜
➜