Filter
Top Products
15
© 2006 directed electronics
panic mode
If you are threatened in or near your vehicle, you can attract
attention by triggering the system with your remote control. Just
press or for two seconds, and you will enter Panic
Mode. The siren will sound and the parking lights will flash for
the programmed siren duration. To stop Panic Mode at any time,
press , or on the remote control again.
valet mode
You can prevent your security system from automatically arming
and triggering by using Valet Mode. This is very useful when
washing the vehicle or having it serviced. In Valet Mode, the
security system will not arm, even with the Remote Control, but
all convenience functions (door locks, trunk release, etc.) will
continue to work normally.
To enter or exit Valet Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
button within 10 seconds.
The status LED will light solidly if you are entering Valet Mode,
and it will go out if you are exiting Valet Mode.
DRW-35
➜
➜