Clifford Falcon II Automobile Alarm User Manual


 
Smart boot release option
If this option was installed, you may use button II to remotely pop the boot. Your
system has a built-in electronic interlock to prevent unintentional activation of the
remote boot release when you drive or when the system is armed.
Smart prior intrusion attempt alert
When you remotely disarm, if you hear 3 chirps instead of the usual one chirp it
means that a trigger or sensor was activated in your absence. When you turn on the
ignition, the LED will flash 1-3 times, pause, then repeat the flash cycle four more
times. Refer to the chart below to identify the trigger or sensor activated.
Number of LED flashes per
cycle
Trigger/sensor indicated
1 flash
Piezo Sensor
2 flashes
Door trigger
3 flashes
Boot or bonnet trigger
Smart AutoTesting
Your Falcon II automatically tests all triggers and sensors every time you remotely
arm. If a trigger is malfunctioning, you will be alerted immediately with 4 chirps
and 4 indicator light flashes instead of the usual 2 and 2. If a door* is ajar or the
sensor is malfunctioning, you will receive the usual 2 chirps and flashes, then, 5
second later, there will be 4 chirps and 4 flashes. If you then remotely disarm and
turn on the ignition, the LED will flash 1-3 times, pause, then repeat the flash cycle
four more times. Refer to the chart above.
Automatic malfunction bypass
To provide protection even if there is a malfunction, Falcon II automatically bypasses
any faulty point and arms all other points to provide the utmost possible protection
until you can have the system serviced by your Authorised Clifford Dealer.
TotalRecall
The system’s non-volatile memory records the identity of the last activated or
malfunctioning trigger or sensor, which allows your installer to instantly track down
a malfunction and save you servicing costs. To identify the trigger or sensor:
1. With the ignition OFF, flick the valet switch to one side.
2. Press button I to “arm” the system, then again to “disarm.”
3. The LED will flash several times, pause, then repeat the flash cycle 4 times.
4. Count the number of flashes in one cycle and refer to the chart above.
* If your vehicle has a factory-installed feature that turns off or dims the interior courtesy lights several
seconds after you exit the vehicle, the system cannot provide this feature.
11