Clifford Model RSX1.2 Automobile Alarm User Manual


 
14
© 2005 directed electronics—all rights reserved
If Passive Mode has been programmed on, then it is also possible
to program the system for Passive Locking. With Passive Locking,
the vehicle doors lock automatically at the same time that the
Failsafe
®
Starter Kill is activated. If Passive Locking is
programmed on, care must be taken to prevent the keys from
being locked in the vehicle.
The remote responds to active arming with one beep and the
Orange LED will flash 3-times to indicate successful locking of
the system.
If after 2-seconds the remote beeps once, the Orange LED flashes
6-times and the Red LED lights for 3-seconds, the system has
detected an open hood.
unlocking
Pressing for one second disarms the system and unlocks the
doors (if connected). The horn will honk twice (if connected)
and the parking lights will flash twice to confirm disarming of the
system. The optional Failsafe
®
Starter Kill will be deactivated.
The in-vehicle status LED will turn off, unless the system is pro-
grammed for Passive Mode. In Passive Mode, the in-vehicle status
LED will flash rapidly when the system is disarmed. This indi-
cates that the system will re-engage the starter kill and re-lock the
doors (if Passive Locking has been programmed) in 30 seconds
unless the ignition is turned on.
nnoottee::
For Passive Mode to be effective, the Failsafe®
Starter Kill relay must be installed.