Filter
Top Products
MS5500 Owner’s Manual - Page 5
Adding a New Transmitter into the System
The MS5500 has the ability to recognize up to 20 individual Remote Transmitters. If the vehicle
is used by multiple drivers, each can have their own Remote Transmitter.
To add Remote Transmitters:
1. Turn on the ignition.
2. Press and hold the Override switch.
• The status LED will turn on red.
3. Within 5 seconds:
Continue holding the Override switch and Press Transmitter Button 1*
For remote arming with chirp confirmation.
--- or ---
Release the Override switch and Press Transmitter Button 1*
For remote arming without chirp confirmation.
• The status LED will flash once quickly to confirm that the new Remote Transmitter
has been added.
4. Turn off the ignition.
* The Button that is pressed will be the Arm/Disarm Button on that Remote Transmitter. You may program any of the
Transmitter’s function buttons to arm and disarm the system at this point.
Deleting Transmitters (Adding a Remote Transmitter and Erasing All
Other Remote Transmitters From the System)
1. Turn on the ignition.
2. Press and hold the Override switch.
• The status LED will turn on red.
Continue to hold the Override switch.
• After 5 seconds, the status LED will flash 4 times, then turn on red again.
3. Within 5 seconds:
Continue holding the Override switch and Press Transmitter Button 1*
For remote arming with chirp confirmation.
--- or ---
Release the Override switch and Press Transmitter Button 1*
For remote arming without chirp confirmation.
• The status LED will flash once quickly to confirm that the new Remote Transmitter
has been added.
4. Turn off the ignition.
* The Button that is pressed will be the Arm/Disarm Button on that Remote Transmitter. You may program any of the
Transmitter’s function buttons to arm and disarm the system at this point.
MS5500_owner’s 1.34.qxd 12/6/99 12:15 PM Page 5