Filter
Top Products
10 CJ-981E
English
Setting the Screen Saver
TIMER Function
In order to avoid forgetting to turn off the screen
in “CAM” mode, a timer function can be set to
automatically turn off the image after a set time.
∗ Default value is “5M” (five minutes).
1. Press the [FUNC] button and switch to the
“CAM” mode.
2. Press the [MODE] button to display the
“TIMER” setting menu.
Each time the [MODE] button is pressed the
menu switches alternately in the order
“CAM” ➜ “MARKER” ➜ … “TIMER” … ➜
“CAM”.
3. Use the [z] and [w] buttons to move the
cursor and highlight the desired timer value.
TIMER
OFF
1M
2M
3M
4M
5M
4. Press the [MODE] button to return to the
“CAM” mode screen.
• After setting the timer, a numeral will
appear in the upper right corner of the
“CAM” mode screen to indicate the
number of minutes until the screen turns
off (5 ➜ 4 ➜ 3 ➜ 2 ➜ 1). Also, when the
countdown time reaches ten seconds, the
remaining time numeral “1” will flash.
Notes:
The automatic screen saver timer OFF does not
operate under the following conditions:
• When the transmission is placed in reverse gear
so that the rear-view camera image is displayed.
• When a video (VTR) image is being viewed from
the video input connector.
• When menu screens are displayed. (After one of
the above operations is performed, the “CAM”
mode timer is reset, and restarts from the newly
reset time.)
Setting the Camera Linked-
Image Switch (CAM AUTO/
CAM HAZARD)
°Automatic linked display
This setting is used to select whether the
camera image is automatically displayed when
the vehicle’s transmission is switched into
reverse gear or linked to the turn signal
circuit.
∗ Default setting is “ON” (linked display).
°Hazard switch linked display
This setting is used to select whether the
camera image linked to the turn signal circuit
automatically appears when the vehicle’s
hazard switch is engaged.
∗ Default setting is “ON” (no linked display).
1. Press the [FUNC] button to switch to the
“CAM” mode screen.
2. Press the [MODE] button to switch to the
“CAM1 AUTO” menu.
Each time the [MODE] button is pressed the
menu switches alternately in the order
“CAM” ➜ “MARKER” ➜ … “CAM1 AUTO” ➜
“CAM2 AUTO” ➜ “CAM3 AUTO” ➜ “CAM2
HAZARD” ➜ “CAM3 HAZARD” ➜ “CAM”.
CAM1
AUTO
ON
OFF
°
Automatic linked display setting
• Linked switching with reverse gear (CAM1
AUTO)
This setting determines whether the
CAMERA1 image signal is automatically
displayed whenever the transmission is
shifted into reverse (when the power supply
box’s CAMERA1 link wire has been wired to
the reverse gear signal).
• Turn-signal linked display (CAM2 AUTO/
CAM3 AUTO)
This setting determines whether the
CAMERA2 or CAMERA3 image signal is
automatically displayed when the turn signals
are used (when the power supply box’s
CAMERA2 or CAMERA3 link wire has been
wired to the turn signal circuit)