Filter
Top Products
37
M475
English
7. ERROR DISPLAYS
If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
If an error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
Error Display Cause Measure
CD/MP3/WMA
ERROR 2 A DISC is caught inside
the CD deck and is not
ejected.
This is a failure of CD deck’s mechanism and
consult your store of purchase.
ERROR 3 A DISC cannot be played
due to scratches, etc.
Replace with a non-scratched, non-warped-disc.
ERROR 6 A DISC is loaded upside-
down inside the CD deck
and does not play.
Eject the disc then reload it properly.
iPod
NO IPOD A communication error
occurs between the iPod
and the iPod CeNET
Interface.
Disconnect the iPod, then connect it again.
CD changer
ERROR 2 A CD inside the CD
changer is not loaded.
This is a failure of CD changer’s mechanism.
Consult your store of purchase.
ERROR 3 A CD inside the CD
changer cannot be played
due to scratches, etc.
Replace with a non-scratched, non-warped disc.
ERROR 6 A CD inside the CD
changer cannot be played
because it is loaded
upside-down.
Eject the disc, then reload it properly.
General
AMP GRD The speaker protection
circuit is operating.
During this operation, if
any volume operation is
performed, the display
shows “AMP GRD”.
“AMP GRD” sometimes
functions when special
test signals are used.
1. Turn down sound volume. Function can also
be restored by turning the power off and on
again.
(Speaker volume is reduced automatically
when the speaker protection circuit operates.)
2. If the sound is muted again, consult our
service department.
M475.book Page 37 Thursday, December 21, 2006 4:08 PM