Filter
Top Products
23
M475
English
Common Operations
AUX function
This system has an external jack input in the front
panel where you can listen to sounds and music
from an external device connected to this unit.
1. Connect the external music player to the
[AUX] input.
2. Press the [SRC] button and select the AUX
mode to activate the AUX function.
Notes:
• Use only the 3.5mm stereo jack for the AUX jack
input.
•
Volume can be adjusted through the unit. If you face
difficulties of hearing sound even after volume has
been adjusted, see “
Selecting AUX IN sensitivity
(AUX mode only)
” in “
Common Operations
”.
Cellular telephone mute
This unit requires special wiring to mute the audio
signal automatically when a cellular telephone rings.
* This function is not compatible with all cellular
telephones. Contact your local authorized Clarion
dealer for information on proper installation and
compatibility.
Changing the adjustment setting
1. Press the [D] button for 1 second or longer to
switch to the adjustment selection display.
2. Press the [R] or [F] button to select the
adjustment item.
Each time you press the [R] or [F]
button, the adjustment item changes as
following order:
“DIMMER” ➜ “CLOCK” ➜ “SID DISP” ➜ “TV/
VTR” ➜ “TV AREA” ➜ “TV DIVER” ➜ “AUX
SENS” ➜ “CONTRAST” ➜ “SCROLL” ➜ “A-
CANCEL” ➜ “TEL-SEL” ➜ “TEL-SP” ➜
“TEL-SW” ➜ “RESET” ➜ “S-CHECK” ➜
“DIMMER”...
The adjustment item name will be displayed
for 2 seconds before showing the setting.
3. Press the [E] or [e] button to adjust the
selected setting.
* When “ENT” is blinking on the display, press
the [ ] button to adjust the setting value.
4. After the adjustment is complete, press the [D]
button to return to the previous mode.
Notes:
• The adjustment setting is canceled when not
operating for more than 10 seconds (except Clock
and Sirius ID setting).
• When each mode is selected, the item shown in
grey will be displayed.
Dimmer Control
You can set the dimmer control.
* The factory default setting is “OFF”.
1. Press and hold the [D] button for 1 second or
longer to switch to the adjustment selection
display.
2. Press the [R] or [F] button to select
“DIMMER”.
3. Press the [E] or [e] button to select “ON” or
“OFF”.
4. Press the [D] button to return to the previous
mode.
Setting the clock
1. Press and hold the [D] button for 1 second or
longer to switch to the adjustment selection
display.
2. Press the [R] or [F] button to select
“CLOCK”.
3. Press the [ ] button.
4. Press the [R] or [F] button to select the
hour or the minute.
5. Press the [E] or [e] button to set the correct
time.
* The clock is displayed in 12-hour format.
6. Press the [ ] button to store the time into
memory.
7. Press the [D] button to return to the previous
mode.
Note:
• You cannot set the clock when it is displayed with
only the ignition on. If you drain or remove the
boat's battery or take out this unit, the clock is
reset. While setting the clock, if another button or
operation is selected, the clock set mode is
canceled.
Connect external music
player via 3.5mm stereo jack
DCP
M475.book Page 23 Thursday, December 21, 2006 4:08 PM