Filter
Top Products
Sirius Satellite Operations
29
M475
English
Notes:
• When the category selection mode is entered, the
category of the last received channel is displayed
first.
• The category selection mode is canceled when no
channel with the selected category can be found.
• Press the [R] or [F] button within 7 seconds
after a channel has been set to continue seeking
channels up or down. The category selection
mode is canceled and normal reception is resumed
if no operation is performed for 7 seconds.
Presetting a category
A category can be preset by registering specific
categories in [DIRECT] buttons 1 to 6. Then the
desired category can be recalled by pressing the
corresponding [DIRECT] button.
1. Press and hold the [BND] button to enter the
category mode.
2. Press the [E] or [e] button to select the
category. Press and hold the button to display
the selections continuously.
3. Press and hold one of the [DIRECT] buttons
for 2 seconds or longer to store the current
category into preset memory.
Notes:
• When the name of a channel stored in memory is
changed by a broadcasting channel, the display
may show a channel name that differs from the
stored name.
• A channel stored in memory may be discontinued
at the option of the broadcasting channel.
Scan function
There are 2 scan modes: a category scan mode
and a preset scan mode.
During scanning, channels are displayed in
abbreviated form and the display mode cannot
be switched.
●Category scan
In a category scan, broadcast channels in the
same category as the current channel are
selected about every 10 seconds.
1. Press the [ ] button to start a category scan.
2. Press the [ ] button, a [DIRECT] button, the
[R] or [F] button to cancel a category
scan.
Note:
• Category scanning is not available when no
category is defined for the current channel.
●Preset scan
A preset scan scans the channels (up to 18
channels) stored in the preset memory about
every 10 seconds.
1. Press and hold the [ ] button for 1 second or
longer to start a preset scan.
2. Press the [ ] button, a [DIRECT] button, the
[R] or [F] button to cancel a preset scan.
To verify your SIRIUS ID
For more information, see “Verifying your
SIRIUS ID (Sirius mode only)” in “Common
Operations”.
M475.book Page 29 Thursday, December 21, 2006 4:08 PM