Filter
Top Products
PIT BOSS
Users Manual
7
Docking the Shop-Hopper with the PIT BOSS
1. Retract the mounting clamps on the PIT BOSS and
remove any frame adapters from the lift arms (see
Figure 6).
2. Position the Shop-Hopper over the PIT BOSS and
align the square holes of the center tubes with the
mounting clamps (see Figure 7).
NOTE:
If the PIT BOSS is not mounted with the table
top flush with the floor the Shop-Hopper must
dock on the lift from the side.
3. Raise the PIT BOSS until the Shop-Hopper fully sits on
the flat of the lift.
4. Slide the mounting clamps fully into the square tubes
of the Shop-Hopper and tighten with a 30mm wrench
(see Figure 8)
Loading a vehicle
When loading a vehicle on to the PIT BOSS lift observe the
following precautions.
CAUTION:
• When driving or winching vehicle
on or off machine, use a helper
to guide.
• When positioning a vehicle over
the lift the vehicle should be
centered over the lift from side to
side as closely as possible.
• The center of gravity of the
vehicle should be as close to the
center of the lift as possible.
• DO NOT exceed 8500 lbs. Lifting
capacity of PIT BOSS lift.
CAUTION:
• Before raising lift, verify that all
lift pads securely mate to a
suitable lifting point on the
vehicle.
• If the frame of the vehicle is too
narrow for the lift arms use the
offset arm mounts.
• ONLY USE THE OFFSET ARM
MOUNTS WITH THE ARMS
FULLY RETRACTED SEE
FIGURE 9
Figure 6
Figure 7
Figure 8
Figure 9