Filter
Top Products
Black plate (75,1)
Chevrolet Cruze Owner Manual (GMNA-Localizing-U.S./Canada-6007168) -
2014 - CRC - 2/22/13
Vehicle Care 10-75
4. Turn the sealant canister (2) so
the inflator filling hose is aligned
with the slot in the compressor.
5. Lift the sealant canister (2) from
the compressor and replace with
a new sealant canister. See your
dealer for more information.
To install a new sealant canister:
1. Align the sealant/air hose (7)
with the slot in the air
compressor.
2. Push the sealant canister (2)
down and turn it clockwise.
3. Wrap the sealant/air hose (7)
around the air compressor
channel to stow it in its original
location.
4. Push the air only hose (6) onto
the sealant canister inlet and
push the lever down.
Storing the Tire Sealant
and Compressor Kit
The tire sealant and compressor kit
is located in the trunk, under the
load floor, behind an access panel.
To remove the kit:
1. Open the trunk. See Trunk on
page 2-15.
2. Turn the left knob
counterclockwise and the right
knob clockwise, 90 degrees, at
the same time. Then pull the
access panel rearward and up to
remove it.