Filter
Top Products
Reprogramming Universal Home
Remote Buttons
Any of the three buttons can be reprogrammed by
repeating the instructions.
Erasing Universal Home Remote
Buttons
The programmed buttons should be erased when the
vehicle is sold or the lease ends.
To erase either Rolling Code or Fixed Code on the
Universal Home Remote device:
1. Press and hold the two outside buttons at the
same time for approximately 20 seconds, until the
indicator lights, located directly above the buttons,
begin to blink rapidly.
2. Once the indicator lights begin to blink, release
both buttons. The codes from all buttons will be
erased.
For help or information on the Universal Home Remote
System, call the customer assistance phone number
under Customer Assistance Offices on page 8‑6.
Storage Areas
Glove Box
Lift up on the glove box lever to open it.
Cupholders
Cupholders may be built into the front center console,
front portion of the front center seat, and rear armrest of
the vehicle.
Sunglasses Storage Compartment
A storage compartment for sunglasses may be located
above the rearview mirror. Push on cover to open the
compartment.
Center Console Storage
For vehicles with a front center console storage area,
open it by pulling up on the latch located in the front of
the console cover.
Rear Storage Area
For vehicles with a split folding rear seat, there are two
storage areas underneath. Pull the tab(s) located by the
passenger side safety belt buckle and the driver side
rear seat to access the storage areas. See Split Folding
Rear Seat
on page 2‑10
for more information.
3-39