Filter
Top Products
After two remote starts have been provided, the
vehicle’s ignition switch must be turned to
RUN and then back to LOCK using the key, before
the remote start procedure can be used again.
If you enter the vehicle after a remote start,
and the engine is running, insert the key into the
ignition switch and turn it to the RUN position
to drive the vehicle.
To manually shut off the engine after a remote
start, do any of the following:
• Aim the remote keyless entry transmitter at
the vehicle and press the remote start
button until the parking lamps turn off.
• Turn on the hazard warning flashers. See
Hazard Warning Flashers on page 154.
• Insert the vehicle’s key into the ignition
switch and turn the switch to RUN and then
back to LOCK.
The remote vehicle start feature will not operate if:
• The remote start system is disabled through
the DIC.
• The vehicle’s key is in the ignition.
• The vehicle’s hood is open
• The hazard warning flashers are on.
• There is an emission control system
malfunction. See Malfunction Indicator Lamp
on page 188.
• The engine coolant temperature is too high.
• The oil pressure is low.
• Two remote vehicle starts have already been
provided.
102