Chevrolet 2007 Express Automobile User Manual


 
Replacing Restraint System Parts
After a Crash
{CAUTION:
A crash can damage the restraint systems
in your vehicle. A damaged restraint
system may not properly protect the
person using it, resulting in serious
injury or even death in a crash. To help
make sure your restraint systems are
working properly after a crash, have
them inspected and any necessary
replacements made as soon as possible.
If you have had a crash, do you need new safety
belts or LATCH system parts?
After a very minor collision, nothing may be
necessary. But if the belts were stretched, as they
would be if worn during a more severe crash,
then you need new parts.
If the LATCH system was being used during a
more severe crash, you may need new LATCH
system parts.
If belts are cut or damaged, replace them.
Collision damage also may mean you will need to
have LATCH system, safety belt or seat parts
repaired or replaced. New parts and repairs may
be necessary even if the belt or LATCH system
was not being used at the time of the collision.
If an airbag inflates, if your vehicle has these, you
will need to replace airbag system parts. See the
part on the airbag system earlier in this section.
If the frontal airbags inflate, you will also need to
replace the driver’s and right front passenger’s
safety belt buckle assembly. Be sure to do
so. Then the new buckle assembly will be there to
help protect you in a collision.
After a crash you may need to replace the driver
and front passenger’s safety belt buckle
assemblies, even if the frontal airbags have not
deployed. On some models, the driver and
front passenger’s safety belt buckle assemblies
contain safety belt pretensioners. If your vehicle
has safety belt pretensioners, have them checked
if your vehicle has been in a collision, or if your
airbag readiness light stays on after you start your
vehicle or while you are driving. See Airbag
Readiness Light on page 169.
99