Filter
Top Products
11
Set the Clock
• Press and hold the HR button until
the correct hour appears. AM or PM
will appear on the radio display.
• Press and hold MN until the correct
minute appears.
Set the time to the time of an FM
station broadcasting RDS information
• Press/hold HR and MN simultaneous-
ly for two seconds until UPDATED
and the clock symbol appear on the
display. If the time is not available
from the station, NO UPDAT will
appear.
Program radio station presets
•Turn the radio on.
• Press AM-FM to select the band
(AM, FM1 or FM2).
•Tune to the desired station using the
seek function or tune knob.
• Press AUTO EQ or AUTO TONE
(as applies to your radio) to select the
sound equalization best suiting the
type of station selected.
• Press/hold a numbered button until a
beep confirms storage of the station.
• Repeat the previous steps for each
pushbutton.
Radio Data System
Your radio’s RDS mode allows you to:
• Seek only stations with your preferred
programming type
• Seek to stations with traffic
announcements
• Receive announcements of local
and/or national emergencies
• Receive and display messages from
radio stations
Toggle between the station frequen-
cy, station name, PTY and the name
of the program if available
• Press DISP.
Activate the Radio Data System traf-
fic announcement feature
• Press TRAF. <TRAF> will appear on
the display if the tuned station broad-
casts traffic announcements.
• If the tuned station does not broad-
cast traffic announcements, the radio
will seek a station that does.
• If no station is found, NO TRAF
appears on the display.
Display a station’s INFO message
when INFO appears on the display
• Press INFO to see the message.
Once the complete message has
been displayed, INFO disappears
from the display.
Tune to an RDS broadcast of a
selected program type
•Turn the P-TYPE knob to select the
Program Type you want to listen to.
• Press the SEEK or SEEK TYPE but-
ton (as applies to your radio).
Switch to a station with a stronger
signal and of the same PTY
• Press and hold the AM-FM button for
two seconds to turn it on; repeat to
turn it off.
Hear an ALERT announcement
“ALERT!” will appear in the display
when a local or national emergency
announcement occurs. If a CD or cas-
sette tape is playing, the announcement
overrides it.
See Section 3 of your Owner Manual.
15804 Trailblazer 6/6/03 4:29 PM Page 11