Chevrolet 170 Automobile User Manual


 
DAILY LIVING
DDoocc NNoo::
21906503
RReevv::
02 Copyright © Hanmar Motor Corporation 2005
BB--1100
WASHROOM FACILITIES:
TOILET:
1. Ensure that you achieve privacy by extending all privacy doors and closing the gallery curtain.
2. See appropriate component Manufacturer’s Owner’s Manuals for operating instructions.
STAND-UP AISLE SHOWER:
To set up the stand-up aisle shower:
1. Remove floor drain cover and drain plug from floor,
(see Picture P-B31).
2. Ensure that you achieve privacy by extending all
privacy doors and closing the gallery curtain.
3. Release the Velcro retention straps and move the
hand held shower from its storage position on the
shelf to its shower position,(see Picture B-P32).
4. Draw the shower curtain until you are completely
surrounded.
5. Using the Velcro connectors, secure the edges of
the curtain together allowing the shower hose to
hang within the shower area to retain any dripping
water inside the curtains.
6. When adjusting the water temperature, be sure to
allow enough time for the temperature adjusted
water to exit the shower head before making
further adjustments.
Note: To conserve water, discontinue the water flow at
the shower head between wetting and rinsing.
To put away the stand-up shower:
1. Rinse and dry the shower curtain thoroughly,(this
function is most easily performed before leaving
the shower area after use).
2. Allow the curtain to air dry completely, (this function
can be expedited using the power roof vent).
3. Replace drain plug in floor when finished.
To prevent grey water tank contents from spilling onto the
floor while driving,keep the drain plug secured when not in
use.
Picture B-P32: Hand held shower head in its shower
position.
Picture B-P31: Floor drain, remove floor drain cover
using the access holes provided in the cover.
Floor drain cover