Filter
Top Products
FRONT LOUNGE SEATS:
To convert the lounge seat into a single bed:
1. Be sure all armrests
are in an upright
position. Swivel the
passenger captain’s
seat 270 degrees
counter clockwise
so that the backrest
is toward the center
aisle,(see Picture
B-P22).
2. Slide out the
drawer under the
passenger seat and
fully extend the
drawer forward
until it touches the
raised platform, (see
Picture B-P23). Raise
the support block
located at the front
of the drawer, (see
Picture B-P24).
3. Lift the back rest
cushion upward,
(on the lounge seat)
remove it from its
metal support and
place it flat on top
of the drawer, with
the tapered end
forward,(see Picture
B-P25).
To convert back to a
lounge seat, perform
these steps in reverse
order.
The lounge seat is designed to carry a passenger while your vehicle is in motion and is equipped with seat belts
installed for their protection.All passengers must be seated in the front captain’s seats facing forward or the
passenger lounge seat with seat belts fastened while vehicle is in motion.All other seats are not to be occupied
while vehicle is in motion.The lap belts must be worn across the hips and not across the abdomen. Passengers
must sit well back in the seat and in an upright position.
DAILY LIVING
DDoocc NNoo::
21906503
RReevv::
02 Copyright © Hanmar Motor Corporation 2005
BB--77
Picture B-P24: Raised support.
Picture B-P23: Extended drawer.
Picture B-P22:Swiveled front captain seat.
Picture B-P25: Front lounge bed.
1
2
3
4