Filter
Top Products
Driver Information Center (DIC)
If your vehicle is equipped with the DIC, it will show
information about the vehicle and the surroundings. It is
located in the headliner between the sun visors.
RESET: You can reset the AVG ECON, FUEL USED
or AVG SPEED trip computer modes by pressing
and holding this button for three seconds while you are
in the mode you wish to reset. A chime will sound to
confirm that your requested change has been made and
all the segments of the display will briefly light up.
To change the display to a metric or English reading,
press the RESET and MODE buttons at the same time.
Hold them down for three seconds and the display
will change. A chime will be heard to confirm the
new selection.
The reset button can also be used to manually calibrate
the compass. See “Manual Compass Calibration”
later in this section.
The reset button can be used to set the compass
zone variation. See “Compass Variance” later in
this section.
MODE: Press this button to cycle through three modes
of operation: Off, Compass/Temperature and Trip
Computer mode.
• Off: No driver information is displayed in this mode
of operation.
• Compass/Temperature Mode: One of
eight compass readings and the outside
temperature are displayed. If the temperature is
below 38°F (3°C), the word ICE is displayed for
two minutes.
• Trip Computer: Pressing the MODE button cycles
through the five displays. Press the MODE button
after the last Trip Computer display to return
the DIC to the OFF mode.
Optional Sunroof Version Shown
3-51