Cadillac 2010 CTS Sport Sedan Automobile User Manual


 
Infotainment System 6-47
To Transfer Audio to the In-Vehicle
Bluetooth System
The cellular phone must be paired
and connected with the Bluetooth
system before a call can be
transferred. The connection process
can take up to two minutes after the
ignition is turned to the ON/RUN or
ACC/ACCESSORY position.
1. During a call with the audio
on the cell phone, press and
hold
b g for two seconds:
.
For vehicles without a
navigation system, the call
transfers to the Bluetooth
system.
.
For vehicles with a
navigation system, the
system responds with a
tone. After the tone say
Hands Free. The call then
transfers to the Bluetooth
system.
Voice Pass-Thru
Voice Pass-Thru allows access to
the voice recognition commands on
the cell phone. See the cell phone
manufacturers user guide to see if
the cell phone supports this feature.
This feature can be used to verbally
access contacts stored in the cell
phone.
1. Press and hold
b g for
two seconds:
.
For vehicles without a
navigation system, the
system responds with
Ready followed by a tone.
.
For vehicles with a
navigation system, the
system responds with a
tone. After the tone say
Hands Free. The system
responds with Ready
followed by a tone.
2. Say Bluetooth. The system
responds with Bluetooth ready
followed by a tone.
3. Say Voice. The system
responds with OK, accessing
<phone name>.
.
The cell phone's normal
prompt messages will go
through its cycle according
to the phone's operating
instructions.
Dual Tone Multi-Frequency
(DTMF) Tones
The in-vehicle Bluetooth system can
send numbers and numbers stored
as name tags during a call. This is
used when calling a menu driven
phone system. Account numbers
can be programmed into the
phonebook for retrieval during menu
driven calls.
Sending a number during a call
1. Press
b g . The system
responds with Ready followed
by a tone.
2. Say Dial. The system responds
with Say a number to send
tones followed by a tone.