Filter
Top Products
G (Trunk): Press and hold for about one second
to unlock the trunk. If the engine is running, the shift
lever must be in P (Park) for an automatic transmission
or in Neutral with the parking brake set for a manual
transmission.
L (Vehicle Locator/Panic Alarm): Press and release
to locate the vehicle. The horn sounds three times and
the turn signal lamps flash three times.
Press and hold
L for three seconds to sound the panic
alarm. The horn sounds and the turn signal lamps flash
for 30 seconds. Press and release
L again to stop the
alarm.
The vehicle comes with two transmitters. Each
transmitter will have a number on top of it, “1” or “2”.
These numbers correspond to the driver of the vehicle.
For example, the memory seat position for driver 1 will
be recalled when using the transmitter labeled “1”,
if enabled through the DIC. See Memory Seat, Mirrors
and Steering Wheel on page 1-8 and DIC Vehicle
Customization on page 3-71 for more information.
Programming Transmitters to the
Vehicle
Only keyless access transmitters programmed to
the vehicle will work. If a transmitter is lost or stolen,
a replacement can be purchased and programmed
through your dealer/retailer. The vehicle can be
reprogrammed so that lost or stolen transmitters
no longer work. Each vehicle can have up to four
transmitters matched to it.
Programming with a Recognized
Transmitter
A new transmitter can be programmed to the vehicle
when there is one recognized transmitter. For vehicles
sold in Canada, two recognized transmitters are
required to program a new transmitter.
1. The vehicle must be off.
2. Both the recognized and new transmitters must be
with you.
3. Insert the vehicle key into the key lock cylinder
located on the outside of the driver door.
4. Turn the key to the unlock position five times within
five seconds.
5. The Driver Information Center (DIC) displays Ready
To Learn Electronic Key #2, 3 or 4.
2-11