Filter
Top Products
Using Cruise Control on Hills
How well the cruise control works on hills depends upon
the vehicle’s speed, load, and the steepness of the hills.
When going up steep hills, you might have to step on the
accelerator pedal to maintain the vehicle’s speed. When
going downhill, you might have to brake or shift to a lower
gear to keep the vehicle’s speed down. When the brakes
are applied the cruise control turns off.
Ending Cruise Control
There are four ways to end cruise control:
• Step lightly on the brake pedal (manual and
automatic transmissions).
• Press the clutch pedal to the floor (manual
transmissions).
• Press [ on the steering wheel.
• Press I on the steering wheel.
Erasing Speed Memory
The cruise control set speed memory is erased when
the cruise control or the ignition is turned off.
Headlamps
The exterior lamp control is located towards the end of
the turn signal/multifunction lever.
O (Exterior Lamp Control): Turn the band with this
symbol on it to operate the exterior lamps.
The exterior lamp control has four positions:
O (Off): Turns off all lamps, except the Daytime
Running Lamps (DRL).
AUTO (Automatic): Turns the headlamps on and off
automatically, depending upon how much light is
available outside of the vehicle.
; (Parking Lamps): Turns on the parking lamps
together with the following:
• Sidemarker Lamps
• Taillamps
• License Plate Lamps
• Instrument Panel Lights
5 (Headlamps): Turns on the headlamps, together
with the previously listed lamps and lights.
3-16