Filter
Top Products
What to Use
Refer to the Maintenance Schedule to determine what
kind of lubricant to use. See Recommended Fluids
and Lubricants on page 6-13.
Rear Axle
When to Check Lubricant
It is not necessary to regularly check rear axle fluid
unless you suspect there is a leak or you hear an
unusual noise. A fluid loss could indicate a problem.
Have it inspected and repaired.
All axle assemblies are filled by volume of fluid during
production. They are not filled to reach a certain
level. When checking the fluid level on any axle,
variations in the readings can be caused by factory fill
differences between the minimum and the maximum
fluid volume. Also, if a vehicle has just been driven
before checking the fluid level, it may appear lower than
normal because fluid has traveled out along the axle
tubes and has not drained back to the sump area.
Therefore, a reading taken five minutes after the vehicle
has been driven will appear to have a lower fluid
level than a vehicle that has been stationary for an
hour or two. Remember that the rear axle assembly
must be supported to get a true reading.
How to Check Lubricant
To get an accurate reading, the vehicle should be
on a level surface.
The proper level is from 0.04 inch to 0.75 inch
(1.0 mm to 19.0 mm) below the bottom of the filler
plug hole, located on the rear axle. Add only enough
fluid to reach the proper level.
5-46