Filter
Top Products
• The high-beam headlamps are manually
turned on or you use the flash-to-pass feature.
See Headlamp High/Low-Beam Changer on
page 183 and Flash-to-Pass on page 188.
When either of these conditions occur,
the IntelliBeam™ feature is temporarily
disabled until the high-beam stalk is returned
to the neutral position. If either of these
conditions occur and IntelliBeam™ already
has the high-beam headlamps on, the
IntelliBeam™ feature is disabled and the
IntelliBeam™ light in the mirror turns off.
• The exterior lamp control is turned to any
setting except AUTO.
When this occurs, IntelliBeam™ is disabled
until the control is turned back to the
AUTO position and the AUTOMATIC LIGHTS
ON message displays on the DIC.
• The IntelliBeam™ system is turned off at the
inside rearview mirror.
• The vehicle’s speed drops below
15 mph (24 km/h).
IntelliBeam™ may not turn off the high-beams if
the system cannot detect other vehicle’s lamps
because of any of the following:
• The others vehicle’s lamp(s) are missing,
damaged, obstructed from view, or otherwise
undetected.
• The other vehicle’s lamp(s) are covered with
dirt, snow and/or road spray.
• The other vehicle’s lamp(s) cannot be detected
due to dense exhaust, smoke, fog, snow, road
spray, mist, or other airborne obstructions.
• Your vehicle’s windshield is dirty, cracked, or
obstructed by something that blocks the view
of the IntelliBeam™ light sensor.
• Your vehicle’s windshield is covered with ice,
dirt, haze, or other obstructions.
• Your vehicle is loaded such that the front end
of the vehicle points upward, causing the
IntelliBeam™ sensor to aim high and
not detect headlamps and taillamps.
• You are driving on winding or hilly roads.
You might need to manually disable or cancel the
high-beam headlamps by turning the low-beam
headlamps on, if any of the above conditions exist.
214