Filter
Top Products
Instruments and Controls 4-9
Compass
The vehicle may have a compass
display on the Driver Information
Center (DIC). The compass
receives its heading and other
information from Global Positioning
System (GPS) antenna, StabiliTrak,
and vehicle speed information.
Avoid covering the GPS antenna for
long periods of time with objects
that may interfere with the antenna's
ability to receive a satellite signal.
See Backglass Antenna
on
page 6‑19
and Satellite Radio
Antenna
on page 6‑19
for the
location of the vehicle's antennas.
The compass system is designed to
operate for a certain number of
miles or degrees of turn before
needing a signal from the GPS
satellites. When the compass
display shows CAL, drive the
vehicle for a short distance in an
open area where it can receive a
GPS signal. The compass system
will automatically determine when
GPS signal is restored and provide
a heading again. See Compass
Messages
on page 4‑34
for more
information on the messages that
may be displayed for the compass.
Clock (Without Date
Display)
The infotainment system controls
are used to access the time and
date settings through the menu
system. See Operation
on
page 6‑7
for information about how
to use the menu system.
Setting the Time
1. Press the CONFIG button and
select Time Settings, or press
the
H button.
2. Select Set Time.
3. Turn the Menu knob to adjust
the highlighted value.
4. Press the SELECT button to
select the next value.
5. To save the time and return to
the Time Settings menu, press
the
0 BACK button at any time
or press the SELECT button
after adjusting the minutes.
Setting the 12/24 Hour Format
1. Press the CONFIG button and
select Time Settings, or press
the
H button.
2. Highlight 12/24 Hour Format.
3. Press the SELECT button to
select the 12 hour or 24 hour
display format.