Filter
Top Products
Replacing components
248
Lamps in luggage compartment lid
License plate lamp
5-watt bulb, C5W
1. Insert screwdriver into the slot and press to
the right, refer to arrows. This releases the
lamp.
2. Remove the lamp and replace the bulb.
Sports Wagon:
Brake lamp and backup lamp
1. Turn the locks to the left and fold down the
trim.
2. Fold down the foam insulation.
3. Pull out the bulb holder for the backup
lamp 1 or brake lamp 2 downward.
4. Backup lamp: remove the bulb for replace-
ment.
Brake lamp: apply gentle pressure to the
bulb while turning it to the left for removal
and replacement.
Changing wheels
Safety precautions in the event of a flat
tire or wheel change: park the vehicle as
far as possible from passing traffic and on solid
ground. Switch on the hazard warning flashers.
Have all vehicle occupants get out of the vehicle
and ensure that they remain outside the imme-
diate area in a safe place, such as behind a
guardrail.
If a warning triangle
*
or portable hazard warning
lamp
*
is required, set it up on the roadside at an
appropriate distance from the rear of the vehi-
cle. Comply with all safety guidelines and regu-
lations.
Change the wheel only on a level, firm surface
which is not slippery. The vehicle or the jack
could slip to the side if you attempt to raise the
vehicle on a soft or slippery surface such as
snow, ice, tiles, etc.
Position the jack on a firm support surface.
Do not use a wooden block or similar object as a
support base for the jack, as this would prevent
it from extending to its full support height and
reduce its load-carrying capacity.
To avoid serious or fatal injury: never lie under
the vehicle, and never start the engine while it is
supported by the jack.<
Online Edition for Part no. 01 41 2 600 310 - © 02/08 BMW AG