Beltronics E936CS Radar Detector User Manual


 
4. Slide the detector onto the mounting
bracket until it “locks” into place.
5. To adjust the angle of the
bracket, squeeze and hold the
circular “buttons” on the sides
of the bracket; this will allow
you to angle the bracket to
your windshield.
Note—some vehicles have a plastic
coating on the inside of the
windshield designed to protect
occupants in case of an accident.
Use of the windshield bracket on this type of windshield
can permanently mark the surface. Check with your dealer
if you are unsure whether your vehicle is equipped with
this type of windshield.
Visor Mounting
1. Remove the two suction cups and follow steps 1, 2, 4 and 5.
2. Clip the detector to the edge of the sun visor nearest
the windshield.
Fuse Replacement
If the fuse has blown, remove the tip from the lighter plug
followed by the old fuse. Replace the fuse with a 1-amp, 3
AG
fuse. Defeating the fuse protection can damage your unit or
your vehicle’s electrical system and will void your warranty.
12